Marble glue to create a new stone seamless process. Gap problem stone mosaic, marble glue to make them perfect.
The so-called stone Seamless renovation process that is already paved in stone adjacent to the gap in order to approximate the color of slate special caulking sealant to be processed, and then the use of professional equipment and technology to the grinding and polishing process. Via After this manner, a large slate will be presented, not as a whole is divided into stone beauty.
Stone Seamless renovation process generally have the following steps:
1, first the gap between the original stone filler clean up, and then use the special sewing machine to open the stone original stone installation raphe realign cut slit to the width of the gap between the poor stone to minimize, and then close the stone colored marble glue them filled. (Note: If you have previously done in the joint treatment is not necessary to re-open seam).
2, near the stone itself using colors and marble glue marble glue perfect palette to make it sufficiently close to the original color of the stone to improve the overall sense, to achieve the best visual effects.
3, a good tune marble glue to fill, since there will be some degree of contraction marble glue completely solidified, it should be slightly higher than the stone marble glue level, so as not to repeatedly fill.
4, grinding and polishing polished fillers, and make the stone into a horizontal plane, to increase the overall sense of stone, and to address the gap between high and low bit problems prevent the gap back to black again. Use granite refurbished machine with special abrasive sheet notches on well-polished bits notches to match the stone as a whole plane.
5, polishing: Use a dedicated granite polishing machine, stone mill No. 50-3000 from thin sheets grinding stone from the rough to the ground resulting in bright and smooth as new.
6, the crystallization process: the use of stone powder and crystalline pharmaceutical crystallization with crystal face grinding machine polishing, sanding and under the weight of the stone so that the crystalline powder physical and chemical synthesis reactions at high temperatures, the formation of a dense, hard protective layer crystallization . After crystallization can enhance the color and brightness, but also to achieve non-slip, waterproof, anti-oil effect.
After the above process, the gap will have a good brightness, and color is very close to the stone, the overall feeling is very strong, but also because the marble glue stain, water, oxidation resistance, will not produce black seam.